Network cable guide for rack-mounted 16-port switch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a cable guide for a rack-mounted D-Link switch, and likely other vendors.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 40
- Makes
- 1
- Views
- 1,305
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
I was inspired by Rheeno's Kabelführung, but the network switch that I normally work with wasn't a good fit for the plug-based design. Rheeno's design was made in TinkerCAD, and I originally started messing around with it myself there, but after a while of frustration, I decided that the easiest way to do it right would be to challenge myself and watched a few tutorials to finally learn Fusion360. After a lot of hair-pulling and eventual catharsis, here is the near-final scratch-made design.
Attached gcode contains some optimizations for speed and quality, with some settings suggested from Priorifi3D (no affiliation, details here). I use ESun PLA+ (no affiliation).
Two 3MF files with these settings and an STL without are provided, along with a STEP file.
The print is optimized to lay with the fully bridged section flat to aid with bed adhesion.
Designed and tested to print without supports on a stock MK3S+.
Changelog
1/23/22 v3:
- More fillets!
- Thickened front to avoid issues with print sagging at the end.
1/23/22 v2.3:
- Increased bracing sizes.
- Cleaned up the model a bit maybe.
1/22/22 v2.2:
- Missed a fillet!
1/22/22 v2.1:
- Fixed new overhang from v2.
1/22/22 v2:
- Fillets everywhere!
- Adjusted the overhang on the top corner to make it more printable.
- Removed unneeded supports.