Multimeter Probe Clamp
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.62 – €0.76 net (excluding VAT)
For file: battester_0.4n_0.2mm_PLA_MINIIS_37m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.69 excluding VAT (range midpoint).
- Weight reported by the author
- 10 g
- Print time reported by the author
- 37.2 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Clamp for turning multimeter into battery tester. Or for just clamping jumper wires to the probes.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 58
- Makes
- 0
- Views
- 493
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to test some button cell batteries but my cheap multimeter had no built in load resistor. This super simple tool help clamp a resistor and dupont jumper wires to the probes.
I used male-male dupont wires, removed the plastic covers on one side and just wrapped a 330 Ohm resistor across. Bend the leads to make sure the probes make contact. This is only for testing low voltage batteries.