120mm Fan Stand with Powerbank Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a universal Fan Stand which can be used to place a powerbank powered 120mm fan wherever you want.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 0
- Views
- 235
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a universal Fan Stand which can be used to place a powerbank powered 120mm fan wherever you want.
Printing
For building the Fan Stand you'll need to print the following parts:
- 1x fan holder
- 1x fan holder, mirrored
- 1x powerbank holder
- 1x powerbank holder, mirrored
- 2x fan grid (optional)
- 4x cylinder (optional)
Note: I didn't upload any mirrored parts but that should be easily done in your printer software.
Powerbank
For my Fan Stand I used the POWERADD EnergyCell 5000mAh Mini Power Bank which is available on Amazon. It has a diameter of 27mm and a length of 110mm. To use a different powerbank, you can design alternative powerbank holders.
Assembly

The Fan is connected to the grids and the fan holder parts with four M4x35mm screws (1). On the bottom side of the screw holes in the fan holder there are cutouts for M4 nuts (2). The powerbank holders are connected to the fan holder parts by M4x10 screws, which are screwed (3) into M4 threaded inserts (4) (I use the ones from Ruthex).
Before screwing the screws (1) through the fan you can support it by placing the four printed cylinders in its corners. This way you can limit the bending of the plastic edges.
Placement

The fan can be placed in different positions: upright, at a 60° angle or sideways. That way it is able to blow air into different directions, depending on your application.
Additional Pictures



Final Notes
I use a custom made PCB (which perfectly fits the 3D-printed fan holder parts) to step up the 5V from the powerbank to the 12V the fan needs. You can alternatively just buy a step up breakout board, e.g. from Amazon to achieve the same effect. In that case you might want to design a simple holding plate that you can screw into the fan holder parts.
Your ideas / criticism, etc.
If you have Ideas for improvements and/or find problems with the design please do not hesitate to tell me. After all that's the best way to further improve the design :)