1 / 1
Keyhole hanger
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This has a keyhole to go over a screw with an 8mm head and a smaller 6mm pin to hang something off.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 19
- Makes
- 0
- Views
- 130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Had a screw already in the wall but the head was too big to go into the whole in what I wanted to hang off it. I created this in TinkerCAD so that the keyhole end will go over a screw with a 8mm head while there is a 6mm pin at the other end to hang something off.
Printed in 11 minutes with 0.2 layer height, 3 walls, no supports and 15% infill it is quite flexible. Increase infill if you want it less flexible.