1 / 11
ESP32 30 Pin Breakout Board Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case with a snap-fit lid to fit a 30 pin ESP32 breakout board.
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 246
- Makes
- 2
- Views
- 691
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Case with a snap-fit lid to fit a 30 pin ESP32 breakout board, you'll find these all over aliexpress/ebay/amazon, etc. The board I designed it off of is ~ 66.28mm wide x 63.3mm long and the PCB is 1.5mm thick.
I made the following updates to the design:
- No supports needed
- Air vents in the top
- No hardware needed to retain the board
- Easier to open and close
I printed it in PETG and it works great.
This is the board I have.
https://a.co/d/eEUognT