Creality K1 Max bowden tube side mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Moving the original bowden tube from being attached in the back to the side for any side mounted filament spool holder.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 71
- Makes
- 0
- Views
- 333
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
I was annoyed with the bowden tube's awkward bend, being attached in the back of my K1 max, while I had changed to a side-mounted filament spool holder.
So I made this over-engineered bowden tube side-mount.
It's best to print it slow, as the parts are thin, and vibration will cause a slightly off-surface finish. I would assume that printing it on a non-CoreXY is also possible if you position it right. Any amount of infill will do as it doesn't have to take much load.
You will need some M3x8 (not longer as it will hinder the belt on the inside) screws to attach it.