GOT7 Bird Magnet

I designed this bird magnet with a GOT7 logo as a freebie to hand out during GOT7 concerts. There is a pocket in the back for pressing in a 6x2mm magnet with minimal force.   

There are two bird designs: a single color bird and a two color bird where I separated out the belly puck. 

Print settings: 

• For reference, I printed using matte green and white PLA on an Ender 3.  
• For the body files (either the single color bird file or the green body files), print them with the design face down on the build plate and without supports. The deboss of the design is just 1mm so your printer should be able to handle it. To be fair, I haven't tried it on a textured plate like the Bambu defaults, but this way the design side surface is clean without needing ironing. 
• For the white belly file, print this without supports and with ironing turned on for a nice finish. 
  • The ironing can cause some amount of top layer “bulging”, hence why I included a few versions of the green body with 0, 0.1, 0.2, and 0.3mm offsets. See which one fits best with the ironed white belly from your printer. 

The magnets honestly are quite cute even without extra effort, but I'm an overachiever so here are extra steps I did: 

• outlined the bird with ultra fine tip sharpies
• used pastel pink acrylic paint for the cheeks
• used pastel yellow acrylic paint for the beak

Disclaimer: the chubby bird silhouette is inspired from this sticker I found online from Axe Wave. They're very clearly an AI art account so do with that info what you will..