AL-KO Robolinho lawnmower canopy roofing adaptor (AL-KO Dachadapter)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
AL-KO Robolinho lawnmower canopy roofing adaptor (AL-KO Dachadapter)
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 29
- Makes
- 0
- Views
- 221
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This adaptor is made for AL-KO Robolinho loading base stations. We use a Robolinho 550W but the same homebase comes with other AL-KO modells. Check the pics.
It is a slide-on adaptor for the main tower to hold an acryllic or wooden roof to protect your lawnmower from rain and sun. My towers dimensions are about 147,50 x 57mm with two round shaped edges in the front. If your tower has the same outer dimensions this adaptor will fit.
There are 4x 6.6mm holes for “melting nuts” in the top as shown on the pics. The distances between the holes are horizontally 123,50mm and vertically 67mm. We used M5x10x7mm melting nuts for M5x10 stainless stell screws with rubber washers below (see pics). Our roof is made from 3mm plexiglas because we only need rain protection.
Works perfect and is very stable (see below printing recommendations).
LASER SERVICE: If you need a plexi/acryllic glass for the roof please feel free to contact us. We can also meet your special dimensions and wishes.
Enjoy!
Material: PETG
Infill: 20% (grid)
Wall lines: min. 3
Layerheight: 0.2mm