Naval Canon 26 LB _18th Century
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.56 – €3.13 net (excluding VAT)
For file: 26 LB Naval Connon 18th Century_0.4n_0.15mm_PLA_MINIIS_3h3m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.84 excluding VAT (range midpoint).
- Weight reported by the author
- 31 g
- Print time reported by the author
- 3.06 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A Model made in Blender of an old Naval Canon from around the 18th Century
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 60
- Makes
- 0
- Views
- 184
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my first model of a Naval Canon made in and around thw 18th Century. I used reference images in order to make this, and this is my first attempt at doing so in Blender. I would have liked to put wooden textures on to the frames, but don't know how to do that yet. If anyone has some good tutorials demonstrating this in Blender I would love to know.
The barrel halves are glued together. The wheels (trucks) should slide on and the axles and the small wedges used to keep them in place. Its axles should click into place but you may have to remove some material or glue them in place. I was able to push them in nice and tight. There is a hole in the rear axle where you put in the saddle (please see images for assistance here), this will probably need gluing in. There are two shackles for attaching the barrel to the frame, one for the left and one for the right. The barrel should rotate up and down and not be glued in so be careful not to stick it in place.
I hope you get as much fun out of this as I did modelling it in Blender?