Carafe 01

I just wanted to clean up some older stuff. But then I wasn't quite satisfied with the handle and I made what felt like a 20 different version. For me, this is a good compromise between appearance and surface quality.The last extension was a scale that marks the volume in 500 ml increments. The carafe holds easily 2000ml.

Warning: 3D prints are not food safe without post-processing. ABS and vapor smoothing might be an option. Food-safe clear coat or beeswax could also be a solution too.

If you like this little thing, you might want to check this too:

 https://www.prusaprinters.org/social/3373-wilko/collections/36089

Print Settings

Supports:

Yes

Notes: 

Obviously the bottom of the handle needs support. But I would also support the grip. If you want to fill water in it I would recommend a third or fourth perimeter.