JST HX dust cover for male end
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a dust cover cap for a JST XH 3 pin plug. Same Plug that the limit switches on the Ender 3 V2 uses.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 63
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
During installation of my CrTouch on my Ender 3 V2 I had to remove the Z-axis limit switch. The wire for this switch was routed in a way that would have been a pain to remove. Instead I zip-tied it out of the way but wanted a cover to keep out debris. I saw plenty of receptacle (female side) dust covers but no plug (male side) covers. Prints in under 10 minutes. Not an absolute perfect fit, but snug enough that it is going to stay on there. I printed it with 7 walls in PLA so it is one solid piece. I may thicken up the clip side wall a bit more if this one breaks pretty quickly. I will upload if I do,
