PC DDR RAM Cooler Mounting Clip - 60mm fan at 90 degrees - transparent
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapted to fit a normal PC, in my case there was no space for the fan due to CPU AIO water pipes too close to the RAM
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 47
- Makes
- 0
- Views
- 1,086
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- GNU General Public License v3.0
Tested on my DDR5 setup with 4 RAM Sticks and the RAM temperature was reduced by 6-8 degrees C.
Includes two models, one is combined, and the other offers capability to separately print the cover (in case you want to print the cover with transparent PLA for RGB RAM modules, or you don't want to print with supports).
PS: The models are not arranged for printing, place the model with the fan mounting point down, and for the cover print it on a side so it prints in a single wall (increases the transparency for transparent PLA, reduces the imperfections seen while RGB RAM is ON).
I would recommend printing the part with the clips or the whole model in PETG (I tried printing the whole model in transparent PLA but the clips are getting lose, due to heat maybe?)
Now I printed the transparent cover in PLA and the fan mount with the clips in PETG.
You can slightly heat up the clips with a lighter or a heat gun and then compress them for a tighter fit.
