Poké Ball Fidget Spinner Button
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.04 – €0.05 net (excluding VAT)
For file: Poke Ball Line Black Spinner_0.2mm_PLA_MK3S_2m_v1.1.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.05 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 1.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Now, Poké Ball Button spins! Remix version. The cylinder and the base both print in place. Assemble without glue.
- Rating
- 0 / 5
- Likes
- 36
- Downloads
- 109
- Makes
- 0
- Views
- 1,285
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Alternative version of my Poké Ball Button (https://www.prusaprinters.org/prints/123575-poke-ball-button)
Update (Jan 28, 2022)
Very minor update to solve unnecessary printing parts in gcode.
Files
Poke Ball Base White Spinner.stl - Base part of Poké Ball with center cylinder print in place. 0.25mm clearance which worked well in Prusa MK3S+ in 0.1mm layer with .4mm nozzle.
Poke Ball Top Red Spinner.stl - Top part of Poké Ball. Standard color is red, use your preferred color for this as you like. Recommended to print in 0.1mm layer.
Poke Ball Line Right Black Spinner.stl - Right side of the line.
Poke Ball Line Left Black Spinner.stl - Left side of the line.
Poke Ball Front Ring Black Spinner.stl - Front ring line part
See gcode files. My recommendation is to use 0.1mm layer height for the spinning base part and top part. Line files are fine with 0.2mm layer height.
Notes
Depending on the printer and the filament, male connector with 35 degrees angle upwards in 1mm thickness may be little challenging. Please use your knife to clean if you see some issue with the upward angle, then it should fit nicely.