1 / 8
Deprecated - Deye 8 kWt inverter exhaust — image 1
1 / 8

Deprecated - Deye 8 kWt inverter exhaust

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Its bad design, Use this one https://www.printables.com/model/1264021-deye-8-kwt-inverter-exhaust

Rating
0 / 5
Likes
2
Downloads
16
Makes
0
Views
829
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

UPD: this is a bad design, 4 x 92mm straight fans work much better.
Use this one 

Helps reduce the frequency of active cooling cycles during high-load periods. Useful when the inverter is installed in confined spaces or areas with poor air circulation.

Hardware:

1x 120mm PC fan with power supply
6x M4*16 bolts
4x M4 nuts
2x M4 copper embedment nuts (I used 4106mm)

Optional: A fan controller to regulate speed and operation (not needed 24/7). I will control mine using Home Assistant / ESPHome based on inverter load metrics.

 

Recommendations:

  1. Prevent filament sagging inside the air channel, as it may reduce performance and create noise.
  2. For easier printing and support removal, the model is split into two parts. However, I have also included a full version if you want to try your luck. 😄
  3. Printing tips:
    * My P1S print profile is attached for reference. BE AWARE OF SUPPORTS—I spent an hour removing them (but still got an almost perfect surface).
    * If using my profile, consider adjusting custom supports for hard-to-reach areas.
    * The model might be printable on its back or side, but I haven't tested that yet.

 

Tags