1 / 8
Deprecated - Deye 8 kWt inverter exhaust — zdjęcie 1
1 / 8

Deprecated - Deye 8 kWt inverter exhaust

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Its bad design, Use this one https://www.printables.com/model/1264021-deye-8-kwt-inverter-exhaust

Ocena
0 / 5
Polubienia
2
Pobrania
16
Wydruki
0
Wyświetlenia
829
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

UPD: this is a bad design, 4 x 92mm straight fans work much better.
Use this one 

Helps reduce the frequency of active cooling cycles during high-load periods. Useful when the inverter is installed in confined spaces or areas with poor air circulation.

Hardware:

1x 120mm PC fan with power supply
6x M4*16 bolts
4x M4 nuts
2x M4 copper embedment nuts (I used 4106mm)

Optional: A fan controller to regulate speed and operation (not needed 24/7). I will control mine using Home Assistant / ESPHome based on inverter load metrics.

 

Recommendations:

  1. Prevent filament sagging inside the air channel, as it may reduce performance and create noise.
  2. For easier printing and support removal, the model is split into two parts. However, I have also included a full version if you want to try your luck. 😄
  3. Printing tips:
    * My P1S print profile is attached for reference. BE AWARE OF SUPPORTS—I spent an hour removing them (but still got an almost perfect surface).
    * If using my profile, consider adjusting custom supports for hard-to-reach areas.
    * The model might be printable on its back or side, but I haven't tested that yet.

 

Tagi