Kodai industries BT-20 Power bank 18650 shell
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My own DIY approach to make 18650 batteries usable with the BT-20 Power bank
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 22
- Makes
- 0
- Views
- 647
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My own DIY approach to make a nice looking 18650 sleeve for the Kodai industries BT-20 power bank.
BT-20 Power bank:
Needs a springless battery contact:
For the positive contact point I used a 8mm rivet head: 8x6mm
You simply press the rivet head with the round side up into the cutout.
you bend the little pin from the springless battery contact in a 90° angle and push it through the inside of the tube outwards.
You then cut it as short as possible and solder it to the rivet head, makes sure it is smooth with the surface and there is no bump the contact of the BT-20 power bank can get stuck to!