Vertical barbell rack mounted holder (3" wide w/ 5/8th bolt hole, Rogue rack)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A power cage/squat rack mounted vertical barbell holder.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 95
- Makes
- 1
- Views
- 496
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Indoor Sports
- License
- Creative Commons — Attribution
- For 45lb power lifting/Olympic bars, or bars with 28mm+ shafts, use “Barbell rack holder - normal 29mm bar”
- For 15lb smaller/curl bars, use “Barbell rack holder - small curl bar.” The other mount will fit fine for these, but this one is a tighter fit.
Vertically mount a barbell on your weight training rack. I slammed a 15lb barbell down on it a few times and it seems to hold fine. I used 6 parameters and 20% infill. Your mile may vary on if it's strong enough for your application.
This is for 3"x3" racks with 5/8th" bolt slots. I used this on a Rogue “Monster Lite” rack.
Also included is a small bolt-end cover. This is if you hang the barbell over a side of your rack with bolt ends sticking out, you can cover them so it's not metal on metal.
The Fusion360 model is included so you can make any adjustments as needed (the 45lb bar is 1.1" + 0.2 in on the bar diameter hole, and 3" + 0.1 in on the collar rest circle). On the 2 I printed I had layer shift issues where the large resting surface is. Not sure why but they came out functional and looked fine after some mild cleanup.
I use the smaller one, but I have not personally stored 45lb barbells on one of these! You might have strength issues, but I believe you'll be fine.
If you use my 3mf/gcode, it'll have my logo on it. The STL does not have my logo.
Printing:
- I used normal Overture PLA.
- MK3s+
- 6 parameters.
- 20% infill.