1 / 1
ZuluSCSI 3.5" Drive Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
DECromancer's new 3.5" mounting bracket for ZuluSCSI and SCSI2SD.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 143
- Makes
- 0
- Views
- 545
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
We weren't satisfied with the prior SCSI2SD v6 bracket that had been floating around, so we made a new one for ZuluSCSI and SCSI2SD. Our new bracket:
- Can be used screwlessly. Slide your device into the channel in the front face, then press down. The rear pegs will hold the device in place.
- If you wish, M3x4 or #4x3/16" screws can be added to the holes in the front to secure the board.
- An alternate version with 4 screw holes (and no pegs) is provided (though we don't print these ourselves).
- Is a full 1" high. Amiga users were particularly unhappy about the old bracket's height
We recommend supporting the PCB channel in the centre, along with the SD card and USB holes, as in the provided 3MF file.