1 / 3
Omniwall version of the DDD Wall Control System
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Omniwall version of the DDD Printable Wall Control System components
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 81
- Makes
- 0
- Views
- 621
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
An Omniwall version of the DDD Printable Wall Control System components. Use these to allow the DDD items to be used with an Omniwall panel. Only components that needed changing will be included. All other components can be pulled from the original project.
Currently available:
- 2x0 left, right, and center
- 8mm Lock Pin - changed to have a 3mm pin. When placing on an Omniwall, sometimes locking spacers do not line up with the pegboard hole, but with a horizontal slot. This lock pin is sized to fit into the slot. Stability is not as good as using the pegboard hole, but it does pretty good at locking the space so it can't move vertically.
- Omniwall tab - can be added to any other model you wish to adapt to an Omniwall. Each tab has a 2.9mm width so that it sits a little tighter in the slot, but should leave enough space to easily insert. Omniwall slots are 3mm wide.