1 / 4
Handlebar Windmill
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
Make your bike ride a little more fun with the small handlebar windmill.
The rotor should be printed without support, the bracket lying on its side with support everywhere but block the hole.
A 1,5 cm long piece of filament is used as an axis, which is melted at the end with a lighter to create the stop. The other end is carefully sharpened with a cutter knife or scissors and inserted with the attached rotor into the opening of the holder.
The bracket can be attached to the handlebars with a rubber band.