Insulin pen case with needle storage (unused and used)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Print in place case that stores a Kwikpen Junior (Maybe other pens that share its dimensions) with needle storage.
- Rating
- 5 / 5
- Likes
- 45
- Downloads
- 286
- Makes
- 1
- Views
- 1,295
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi all!
So, at the beginning of 2025, my kiddo was diagnosed with Type 1 Diabetes. It has been a ride, but of all the challenges, handling an insulin pen on the go was one of the most annoying. Especially safely managing used pen tips until we could get to a proper sharps disposal.
So, I made this!
Currently sized to fit a Kwikpen Jr (once I get some more pen measurements, I can expand this or make more), and the standard pen needle tips. Fresh pen tips stick in label-up into the inner cones. Used pen tips click right back in, unprotected side down (You don't have to push hard/straight down. They can click with a tilt, and then lever into place). When you're back to a place with proper sharps, just lever the tips towards you and they should pop right out.
And what's the big tower thing? It's both to hold the pen in place, and I had an idea: When the model is sliced to a layer height of .2mm, it should bridge out a small one-layer thick bridge. The idea is that if the case is printed in PLA, and the pen is ever exposed to 50C/130F temps (like, being left in a car in summer, or a backpack in direct light), this layer should degrade, indicating the insulin may be compromised. I'm not fully sure it works as thought yet, but I'm leaving in place.
(and ignore the poor quality of this layer in the photo; I accidentally printed at .15mm layer height for this one).
Print in place hinge with pretty close tolerances. Let me know if it's tricky for you to print.
Planned improvements:
- Improved latch
- Magnets!
- More pen compatibility
- A more compact version that can be printed on Prusa Mini and other 180mm printers.
- Testing on the sacrificial temp indicator
- Alcohol wipe storage that's convenient.
- Filament use improvements. Currently uses ~120g filament with 15-20% infill. I want to see if I can get it down to <100g.
- Biohazard logo, warning logos, or similar, just to help people be aware they could be opening a case with sharps.
- MMU presets - Beause I'd love to make an ABS/PLA case, where costs can be controlled even more with an ABS case that has a PLA heat indicator. But this is way down the road.
If you have an improvement you'd like me to make, let me know!