Prusa Core One Thermometer/Hygrometer Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slim bezel for great visibility, with a compact and clean design!
- Rating
- 4.9 / 5
- Likes
- 78
- Downloads
- 259
- Makes
- 11
- Views
- 1,501
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
A thermometer/hygrometer holder that is installed inside the Prusa Core One enclosure using magnets.
This holder is designed to replace the stock case that comes with the thermometer/ hygrometer. It has a slim bezel for better visibility, a compact form, and a clean design.
Required other than printed parts:
- 5× 6x3mm magnets
- 1x Thermometer/hygrometer
Disassembly Thermometer/Hygrometer:
Press the two snap-fit tabs on each side (four in total) to release the fit, and then remove the internal parts.
Assembly:
1. Reinsert the removed parts and snap the four snap-fit tabs into place. If fitting the back cover is difficult, you can try inserting the two snap-fit tabs marked in red in the image first, then gently tap the opposite side using a hammer and a mallet block.
2. Push a 6x3mm magnet into the hole and apply super glue if necessary.
Notes:
- It's necessary to adjust the scale factor to match the filament in use, considering material shrinkage. In my case, I use 100.5% for PETG and 101% for ABS.
- When disassembling or assembling the thermometer/hygrometer, removing the battery cover reduces the frame's rigidity and increases its flexibility, making the process easier.