1 / 10
EVA2.3 carriage for Ender 3 / 3V2 / Clones with linear rail — image 1
1 / 10

EVA2.3 carriage for Ender 3 / 3V2 / Clones with linear rail

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a remix of three parts to fit the EVA2 carriage (for different extruders and hotends) to an Ender 3, Ender 3V2…

Rating
0 / 5
Likes
7
Downloads
23
Makes
0
Views
375
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

This is a remix of three parts to fit the EVA2 carriage (for different extruders and hotends) to an Ender 3, Ender 3V2 or Ender clone with x-axis linear rail installed in front of the 20x20 extrusion profile. Standard EVA2.3.0 only works with core-xy, idex (e.g. rat rig) or cartesian printers (e.g. Ender 5) with linear rails mounted on top the extrusion profile, see https://github.com/EVA-3D/eva-main or https://main.eva-3d.page/ or https://www.thingiverse.com/thing:4326652/files

This is more of a demonstrator and test for my hotend and extruder parts but works really well.

You will need:

If not already installed:

You need to have a look at:

  • The belt orientation: the belt is connected from above, not from below as usual, so you need to reverse the motor rotation. Easiest way is to plug the connector on the mainboard for the x axis the other way round or change the cables within the connector. You can do it also by software but you need to know what you are doing (see https://drucktipps3d.de/quickie-motorrichtung-aendern/).
  • The x endstop switch: the endstop has to be raised 6-8mm so it is just in front of the linear rail. You can use 4x M3 threaded standoffs.
  • The cabling: route the cables above the rail to the cable holder, so you don't lose printing area or risk damaging the wires. You can use the square holes in the face plate for zip ties.
  • The printing area: depending on your printer and cabling you could lose up to 5mm on each side, but you can file or grind the z-axis plates a little bit where the fan duct touches. Print Settings

Printer Brand:

Creality

Printer:

Ender 3

**Rafts:**

No

Supports:

No

**Resolution:**

0.2 or 0.3

Infill:

20

**Filament:** Geetech PETG blue, black

Notes:

  • Printing orientation as shown in pictures, .stl files are already in the right position
  • No need for support: there are sacrificial layers used where needed, just cut or drill them open aferwards
  • A brim for fanduct might be the right choice for the fan duct to get better bed adhesion
  • Don't use PLA for the face part or any EVA2.3.0 parts in contact or near the hotend
  • I recommend using at least 4 wall lines and at least 20% infill

Category: 3D Printer Parts

Tags