Kung Fu Flash Cartridge Shell
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a shell for a Kung Fu Flash cartridge for Commodore computers.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 28
- Makes
- 0
- Views
- 158
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
A cartridge shell for a Kung Fu Flash cartridge, and it should work fine for the Kung Fu Flash 2. Tolerances are pretty tight, but that means there's very little movement of the PCB inside the shell… Unlike the model I derived it from, the front at least might need support depending on how good your bridging is (didn't like the way the label area looked… should have just used a different model. :P) Buttons also need support for the divot.
Edit: Added a second version of the top piece with smaller holes if you have a version of the PCB with the longer buttons and don't want to use the caps. Also added STEP files for everything
I also published the cart without the holes in case people just want a solidly made stubby cart.
As you will note, this one does NOT have the same restrictions against commercial use that other versions have, but it DOES have Share-Alike, so you can sell them if you like, but if you make tweaks, you have to publish them.
Also, if anybody's making Kung Fu Flash 2 carts and actually wants to do hard gold fingers rather than cheap out like most people seem to want to do, if you want to send one my way as a thank you… :P