Stonks AKA "Meme Man" Mask
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Had a request to make a Halloween costume for a friend. Used the "Enslaved Plastic" model as a base, then used…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 19
- Makes
- 0
- Views
- 192
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Cosplay & Costumes in general
- License
- Creative Commons — Attribution
Had a request to make a Halloween costume for a friend. Used the "Enslaved Plastic" model as a base, then used Meshmixer to hollow+thicken and repair any mesh-errors.
Tried printing at 249mm high. First print was at ~45 deg. angle and fell over after 5 hours. Second print was straight vertical with 5% infill support and .2mm X/Y/Z distance.
Support Settings:
Supports: Tree Infill: 5% Pattern: Grid X/Y Dist.: 0.2mm Z Dist: 0.2mm Tree Support Branch Distance: 0.8mm Tree Support Branch Diameter Angle: 7 deg Support Overhang Angle: 40 Tree Support Branch Diameter: 3mm Speed: 50mm/s
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
No
Supports:
Yes
.2
Infill:
15%
Supports began to fuse with the base, which is understandable given my tight tolerances. I used a dremel and some sandpaper to remove the excess filament.
Category: Costume