Nuki Smart Lock Pro Gen 5 - Mounting Kit for knob cylinders (EVVA)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The new Nuki Smart Lokc Pro Gen 5 cannot be mounted to a cylinder with a knob which is solved with this kit.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 318
- Makes
- 0
- Views
- 2,431
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
The new NUKI Smart Look Pro Gen 5 cannot be mounted to a cylinder with a knob and since I don't want to replace the cylinder and go with the NUKI Smart Look Ultra, I designed a mounting plate and a replacement for the knob which fits in the SmartLook Pro Gen 5 slot.
My design is currently for EVVA cylinders. If you use a different one, you either download and modify the .stl file or you can directly get it from OnShape.com (as you can see, I am not a CAD expert 😅)
Please note: This is the first version and might still have some weaknesses which might show up during usage. From my experience and expectation, there are two potential weak points for the EVVA Knob Adapter.
- The transition between the Knob part and the plate which is just 4mm x 16mm and transfers the force from the motor to the cylinder.
- The hole for the pin of the cylinder which again transfers the force to the cylinder. At least PLA seemed not to be the best choice but since I have kids and they do stupid things from time to time, it might be an unrealistic high force 😜
Please also note that currently the inner diameter for the knob replacement is quite tight, but better expand it afterwards a bit, if needed.
Printing
The Door2Nuki Adapter can be printed with any material. I suggest printing it up-side down. Just keep default print settings like 20% infill, 0.2 mm layer hight, etc.
The EVVA Knob Adapter is a bit tricky. For the diameter it would be best to print it with the knob hole downside but then the transition to the plate is the weak point because it fully relys on the layer adhesion. I printed it with the plate parallel to the printbed. My current print is ABS and I hope it is stable enough, however, I assume that the pin hole might be the problem again after time. So maybe next time I will print it with PA-CF. I printed it with 0.2 mm layer height and 90% infill.
The best thing you can do is to ensure that the mechanism of your door lock can be moved with as little force as possible.
If you have any ideas or suggestions for improvement, please let me know.