1 / 2
X-Shot Pro Fury X Picatinny Top Rail (Angled & Straight)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Picatinny Top Rails for the X-Shot Pro Fury X, uses M3/toy screws
- Rating
- 5 / 5
- Likes
- 81
- Downloads
- 450
- Makes
- 10
- Views
- 1,756
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
This an Picatinny Top Rail piece for the X-Shot Pro Fury X, replacing the ratcheting lever located on the top of the blaster. It uses a screw to lock the rail into place.
Comes in angled and straight picatinny variants. The angled one is angled down 1.5 degrees, and uses a M3x10 screw, whereas the un-angled variant needs a shorter 8mm length screw.
HARDWARE NEEDED:
(1) M3x8 machine screw OR (1) toy screw of similar length
PRINT SETTINGS:
Printed with bottom-front slant on bed, as shown below.
Supports required.
