1 / 2
X-Shot Pro Fury X Picatinny Top Rail (Angled & Straight)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Picatinny Top Rails for the X-Shot Pro Fury X, uses M3/toy screws
- Ocena
- 5 / 5
- Polubienia
- 81
- Pobrania
- 450
- Wydruki
- 10
- Wyświetlenia
- 1756
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 10) (Komentarze: 20)Remiksy (0)Kolekcje (141)Powiązane
This an Picatinny Top Rail piece for the X-Shot Pro Fury X, replacing the ratcheting lever located on the top of the blaster. It uses a screw to lock the rail into place.
Comes in angled and straight picatinny variants. The angled one is angled down 1.5 degrees, and uses a M3x10 screw, whereas the un-angled variant needs a shorter 8mm length screw.
HARDWARE NEEDED:
(1) M3x8 machine screw OR (1) toy screw of similar length
PRINT SETTINGS:
Printed with bottom-front slant on bed, as shown below.
Supports required.
