Sovol SV08 Mosfet Fan Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bracket to add a fan to the mosfet.
- Rating
- 5 / 5
- Likes
- 35
- Downloads
- 204
- Makes
- 2
- Views
- 1,013
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
A simple bracket to add a 8010 fan for the mosfet that controls the bead heating.
Make sure the sticker points down when attaching the fan! The bracket is mounted with m4 bolts and t nuts to the 2020 extrusion from the printer.
Basic Fan Configuration in printer.cfg
[fan_generic fanX] #mosfet fan
pin: PA6
max_power: 1.0The pin may vary depending on where you plugged the fan in, check the documentation!
You can add the new fan “fanX” in the START_PRINT and END_PRINT macros in the macros.cfg or sovol-macros.cfg to automaticly turn them on/off.
BOM
1x 8010 24V fan (Amazon or AliExpress *)
2x M4x8 bolts (Amazon or AliExpress *)
2x M4 t nut (Amazon or AliExpress *)
4x self tapping fan screws
*This link is a affiliate link, which means I may earn a commission at no extra cost to you.