Fridge Protector (Dometic Camping Fridges)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.11 – €0.13 net (excluding VAT)
For file: Fridge_Evap_10mmPacker_x4_0.4n_0.15mm_PETG_MK4IS_9m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.12 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 9 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A vane protector for the vulnerable/exposed cooling vanes on Campervan / Caravan / Motorhome fridges
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 74
- Makes
- 0
- Views
- 1,140
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Not so much a repair, as avoiding very costly damage.
Dometic Campervan / Caravan / Motorhome fridges are deliberately built light and flimsy, this goes for the evaporators in them as well. Worse the protection for these light evaporator vanes is useless, especially if you have a fully loaded fridge with the contents moving around in transit.
This is a light ‘small footprint’ evaporator protector that simply clips on to the fridge shelf. It is non-permanent, held in place by x4 small packers, which means it will only come off when you want it to.
STL for the protector and packer included. BGcode prints the protector with a little enforced support for the larger side holes. BG code prints 4 x 10mm packers (for each end of the supports), if you want to lock the middle rack bars I have produced a 5mm packer, but I haven't used them. The protector prints back face down - with the supports rising up from the bed. The packers print end on.
I printed in PETG since waterproof and suitable for food contact (no plasticer migration - don't use PLA - not food grade)