Visualiser for Creality Ender 3 V3 SE
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Visualiser (and extruder stepper-motor face plate) for Creality Ender 3 V3 SE
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 88
- Makes
- 1
- Views
- 748
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a visualiser (and face plate) for the stepper motor used on the extruder stepper motor.
If you've performed a fan upgrade and can no longer use the supplied shroud, you're left looking at the ugly-branded stepper motor. This print allows you to cover that for a more clean look, and also adds a visualiser in the form of the Creality logo.
The cover requires two M3x6 hex/socket screws, and is very easy to install.
The adaptor I would strongly recommend printing at 0.12 (Fine) and at a significantly slower speed.
The logo itself can be printed in a different colour. I used Bambu glow-in-the-dark green. Again I would recommend printing at 0.12 and slower.
The two parts should snap together fairly well, but if it's a bit loose, you can use TINY dab of superglue to join the adaptor and logo together, be VERY sparing.
The whole lot should then push-fit onto the screw on the printer. You'll need to line up the slot of the screw. I would advise against using glue here.
Works well with the following mods from other users (shown in my photo)
https://www.printables.com/model/852875-ender-3-v3-se-4020-4010-fan-mount
https://www.printables.com/model/776657-ender-3-v3-se-5015-fan-upgrade
https://www.printables.com/model/666174-40mm-fan-guard-hex
Important note:
It has been pointed out to me in the comments that Creality ships some models of this printer with alternative extruder. I'm not yet clear on how/why this happens, but it's possible this model may not fit yours. I don't have any measurements to be able to adjust it.