1 / 4
Dual Fosi Audio V3 Mono Box with Fan — image 1
1 / 4

Dual Fosi Audio V3 Mono Box with Fan

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A nice box to host a couple of Fosi Audio V3 Mono amps with a fan.

Rating
5 / 5
Likes
14
Downloads
136
Makes
1
Views
1,002
Reviews
1

Updated at source:

Model information

Category
Audio
License
Creative Commons — Attribution

I needed a compact and efficient way to organize four mono amps for a DIY speaker system upgrade, so I designed this enclosure to house two of the amps along with a 120mm fan mounted at the bottom.

In my setup, I'm using the “audiophile-grade” Noctua NF-A12x25 5V PWM fan, controlled by a Raspberry Pi to run at 50% speed only when music is playing. However, any standard 120mm x 25mm fan with speed control should work just fine. At this speed, the fan adds only ~2dB over ambient noise—completely inaudible from my listening position. When the fan is off, the design still allows for sufficient passive convection cooling to keep the amps operating within a safe temperature range.

Hardware Needed:

  • Four M4x30 screws (for fan)
  • Four M4x6 screws (for attaching the feet)
  • Noctua NF-A12x25 5V PWM or other 120mm x 25mm fan with speed controller.

Printing Details:
Printed in PLA using a Bambu X1C in approximately 9 hours. No supports needed.

Note:
Thinking about it, it might work well even without the fan. Leave me a comment if you'd like to see a version without it!

Tags