Slim AirTag Wallet Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
AirTag case mod that fits in a credit card slot. 3mm slim, uses CR2025 batteries, water-resistant.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 69
- Makes
- 0
- Views
- 577
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple housing to modify an Apple AirTag so it fits into a wallet's credit card slot. It’s only 3mm thick and works with one or two CR2025 batteries.
The case is designed to be water-resistant (I keep leaving my wallet in the wash). That said, the level of waterproofing depends on how well the glue seal is applied.
Print both parts (case + lid) and glue them together. I use Pattex glue with ABS filament because it holds well but can still be undone to replace the batteries. Acetone + ABS works too, but fully fuses the parts so they cannot be undone.
Print Settings
Material: ABS
Layer height: 0.12mm (Fine) on Creality K1 (0.4mm nozzle)
Walls: 5 loops
Top layers: 5 (rectilinear)
Bottom layers: 5 (rectilinear)
Infill: 30% (rectilinear)
Other Materials
Adhesive: Pattex Kraftkleber Classic
Wire: 0.8mm (non-Teflon)