Aeropress GO mug extension
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extension to make Aeropress GO mug hold Fellow Prismo on top. Now you can have all accesories tuck nicely under cover
- Rating
- 5 / 5
- Likes
- 44
- Downloads
- 259
- Makes
- 5
- Views
- 2,372
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
As I got Aeropress GO and Fellow Prismo “espresso” filter, there were no chance to hold them together covered by that nice red cap. So after few iterations, there is a mug extension, that can now hold not just Prismo but event filter case under cap with still some spare room.
Simply slide the extension on mug from bottom all the way up, it will hold there by nice amount of friction. Put everything you need inside the mug and put the cap on. You need to stretch the lid over the edge of extension by finger a little bit.
Best to print with PETG as its more flexible than PLA
Layer height of 0.2mm, no other special requirements ;)