1 / 2
TP-Link Omada EAP Wifi Acces Point Vertical Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stand to keep TP-Link Access Points neat and tidy
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 63
- Makes
- 0
- Views
- 632
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Public Domain
These TP-Link access points are supposed to be mounted on the ceiling but I'm renting so that's out of the question.
The access points work fine just placed on a surface but that looks messy and takes a lot of room too so I made these access point stands which look a bit better and give me some surface back.
Features:
- Big hole at back for Ethernet and power
- Chunky and heavy: with 15% infill these used more then 550g each
- Circular cut-out to stop the access point rolling away
Print settings
- Same as Prusa printed parts
- 15% infill, grid
- Brim recommended
- Tree supports recommended
- Important: print on side to strengthen the lip
Pictured: EAP-680. You can use the test fit file to print out the slot section and see if your model fits. It should fit any access point 35mm deep and 22cm diameter.