1 / 2
TP-Link Omada EAP Wifi Acces Point Vertical Stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand to keep TP-Link Access Points neat and tidy
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 625
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Public Domain
These TP-Link access points are supposed to be mounted on the ceiling but I'm renting so that's out of the question.
The access points work fine just placed on a surface but that looks messy and takes a lot of room too so I made these access point stands which look a bit better and give me some surface back.
Features:
- Big hole at back for Ethernet and power
- Chunky and heavy: with 15% infill these used more then 550g each
- Circular cut-out to stop the access point rolling away
Print settings
- Same as Prusa printed parts
- 15% infill, grid
- Brim recommended
- Tree supports recommended
- Important: print on side to strengthen the lip
Pictured: EAP-680. You can use the test fit file to print out the slot section and see if your model fits. It should fit any access point 35mm deep and 22cm diameter.