2 inch sanding disc organizer - 2 pads

This fits 20-each of 12 different grit sanding papers plus two different back plates and pads, as supplied in the kit I ordered.

I printed up labels for either side to label the grits, but didn't want to mark up the model to embed them in case people wanted different sets/ordering, and the printed labels are easier to read than embossed/debossed text. Just make sure your label fits within 3.75" and you should be all set.

I was not able to fit all of the 80-grit discs in the available space, so I stuck a few underneath one of the pads instead. Everything else fit, although it was an increasingly tight squeeze as the grits got lower: the disc storage is slightly narrower than the discs, so they benefit from buckling a little bit as they go in. That wasn't an issue for me because they came slightly bent, and the pads will provide enough cushioning or flattening (as appropriate) for my uses anyway. There is no dedicated space for the two extra shanks, but I expect to store them behind the box for now.

Printed in Sunlu matte white PLA, anything should be fine. Used 0.3mm layers as in the original, no supports or anything fancy is required.

Licensed under Creative Commons Attribution, since that's what the original was licensed as. Thanks to Ray for the original!