Ender 3 NG v1.2 electronics panel chamfered logo
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ender 3 NG v1.2 electronics panel chamfered logo
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 140
- Makes
- 2
- Views
- 435
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
This is a separate logo model for the Ender 3 NG v1.2 electronics panel! Scale the Z axis in your slicer to add a custom depth. The print in the photo is about 50% height.
Instead of bothering with multi-color prints, print the electronics panel in one color, print this model, and super glue the logo onto the electronics panel instead. Use the logo outline on the electronics panel as a guide.
This is a decorative part and sees no physical stress, so it's not important to use a lot of super glue. I recommend cutting a q-tip in half at an angle to create a sharp paper brush out of the handle, putting just a little bit of glue on the tip, and drawing small ~2 mm flat circles of glue on the panel. Put them in the corners, ends of extrusions, and the middle of long areas. Then, carefully place the logo on the panel. You'll have about 10 seconds or so to reposition the logo before the glue starts to harden. Press down on the logo with your fingers, and wait a good 5 minutes or so for it to bond, then let sit for about an hour.