1 / 8
Bee Hotel
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
A simple Bee Hotel made of two parts:
- Inner housing to fit in tubes and other elements
- Outer body for decoration
I made this model to replace my old bee hotels which were old and rough weather broke them apart, so I moved some tubes and added new tubes as well.
It's easy to print, no supports needed.
You can use adaptive cubic infil to save a bit of filament.
I used Overture Brown and Black Petg to print both variants, with 0.20 layer height.
To hold both parts, I added inner hole for a small screw.
Note: on the Bamboo outer body printed results you may see I have a few layers of different colours - I did it intentionally because brown filament was at the limit to finish before the print is over.