Stable Base for Holster Based Meshtastic Solar Nodes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Very Stable Base for Meshtastic Solar Node. Great for non invasive flat roof installation just put some sandbags on feet
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 32
- Makes
- 0
- Views
- 345
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This stand was made for use with these holster based Meshtastic Harbor Breeze solar node designs:
SMA: https://www.printables.com/model/1275240-minimalist-sma-harbor-breeze-meshtastic-off-grid-s
N-Type: https://www.printables.com/model/1245724-minimalist-n-type-harbor-breeze-meshtastic-off-gri
Long: https://www.printables.com/model/1225732-harbor-breeze-meshtastic-solar-node
It was designed to be as stable as possible on a flat roof. Large pads on the feet can be used to put sand bags on or other heavy objects. You can also just use 3m double sided tape as well if desired.
No supports are needed for this print. There is a small drain that goes through the middle so it doesn't fill with water. After printing just slide your node in and your done! Make sure to print with a material that is UV resistant. NOT PLA!