1 / 3
Stern Pinball Uncanny X-Men Sentinel Head Guides — image 1
1 / 3

Stern Pinball Uncanny X-Men Sentinel Head Guides

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two pieces I'm experimenting with in an attempt to reduce ball on metal collision jankiness behind the Sentinel Head.

Rating
0 / 5
Likes
4
Downloads
36
Makes
0
Views
273
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Check out my post on the Pinside UXM owners' thread for a full writeup for this beta release.

The first piece (Sentinel Ramp Washer) is basically a tall plastic replacement for the washer back there. It has a counterbore for the screw and a tail that bridges the gap between the wires from the Midtown ramp and the Subway guide wire. Take out the screw with the washer holding the wireform down, ditch the washer, run the screw through the new part, and screw it back down. The tail of the piece should align with the guide wire running down into the playfield.

The second piece (Sentinel Head Diverter) slips over the guide wire directly behind the sentinel head and extends downward a bit so that balls can't collide on the downfield facing portion of the wire. Those little ramps are angled back down the playfield, so any balls that end up on the sentinel head and roll onto my part won't get stuck there.

I'm using ASA filament for a little bit of flexibility to allow a very snug fit of the second piece over the wire directly behind the head as well as strong impact resistance. PETG would probably work just fine. If you only have PLA, you're welcome to try it out and let us know if it holds up. You may need to scale it up a tiny bit to get the second piece to fit down over the wire. 

Tags