Vase Mode Overhang Calibration
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A model to test and calibrate the limits of overhang while in vase mode
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 43
- Makes
- 1
- Views
- 141
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial
NOTE: Please honor and adhere to the license of this model. Commercial use is prohibited and not allowed.
I plan to create some designs intended to be printed in vase mode. To test/design the limits of what one can do in vase mode, I created this model to test the various overhang angles one can successfully print while in vase mode. This model prints overhangs from 5-degrees to 75-degrees.
On my Prusa i3 MK2S using a 0.4mm nozzle and a 0.12mm layer height, I was able to successfully print with no artifacts up to 65-degrees. 70-degrees also successfully printed, but there was some light artifacts. I was not able to print with a 75-degree overhang in vase mode.