Nikon FE/FM Camera Grip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed a camera grip for my Nikon FE Film Camera to increase the level of grip especially when shooting portraits.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 53
- Makes
- 0
- Views
- 208
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
This is a model for a Camera grip that was made for a Nikon FE film camera. I feel like it will definitely fit other Nikons of the same era such as the FM or FE2, but I didn't have them on hand to test it.
The camera is fully usable with the grip installed and you don't need to take it off to load film, rewind, etc.
FOR BEST RESULTS PRINT IN CARBON FIBRE PLA, PETG MAY ALSO WORK WELL.
Standard PLA didn't have enough strength in my tests. I also printed it with 100% infill and that seemed to give the best results. Some tweaking with slicer settings may make it more efficient too.
OTHER REQUIRED MATERIAL:
1x D-Ring 1/4" Tripod Screw with 10.5mm long shaft.
They are easily found on amazon or other similar sites. Regular Tripod Screws would also work but I just prefer the D-Ring sort because you don't need a coin or anything else to tighten or take it off.