Bike Handlebars (25mm) Camera Mount Adapter (for my Cycliq 1/8 Turn Mount C) - for Fly12
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an adapter to mount my printed Fly12 twist-lock bracket above my handlebars. It must be used with my 'Mount C'
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 182
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This adapter is designed to work specifically with my 1/8 Turn Mount Bracket C (that actually connects to the camera twist lock). This adapter is just to mount that bracket on the handlebars, with the intent being that this adapter can be adjusted for different bar diameters while maintaining the best print orientations of both this adapter and the mount bracket. There is a mating pyramid/pin to hold the bracket nicely in place.
While I undersized the pin quite a bit, print resolution seems to result in always needing to clean up the four pyramid faces with a file to get a nice clean fit. Only takes a minute or two, and the fit is great after, so I'm happy with that amount of post-processing being required.
This adapter requires an M4x20 SHCS and nut to clamp the bars.
This particular model is for 25mm bars, but I intend to make a few sizes. It is a tight snap around the bars, so watch your fingers.
I printed on the flat side with a 0.6mm nozzle, no supports, 0.3mm layer height, and a bit of extra flow rate, in PETG-HF.