VZBOT Poop chute

I developed this poop chute for printing on my VZ with several materials 

You will also need an aluminum tube. 20*40*1,5 

I cut and bent the insert into the bucket from stainless steel 0.5mm thick. 

For assembly, you will need M3 and M4 screws of different lengths. 

Since this project is not very suitable for newbies, I will not write a detailed BOM and build guide. Also, JUST FOR AN EXAMPLE, I'll leave my cleanup macro here. In any case, do not insert it thoughtlessly! You can ruin the printer! 

gcode:   
 {% set current_speed = printer.fan.speed * 255 %}
 {% set temp = params.TEMP | default(0) | int %}
 {% set current_x = printer.toolhead.position.x %} 
 {% set current_accel = printer.toolhead.max_accel %} 
 SET_VELOCITY_LIMIT ACCEL=40000
 M106 S0
 {% if current_x < 335 %}
   G1 X327 Y68 F15000
   G1 X335 F8000
 {% endif %}
 G1 Y69 F8000
 G1 Y61 F8000
 G1 Y69 F8000
 G1 Y61 F8000
 G4 P500
 G1 Y69 F8000
 G1 Y61 F8000
 G1 Y69 F8000
 G1 Y61 F8000
   
 {% if printer.extruder.temperature < 200 %}
   SET_HEATER_TEMPERATURE HEATER=extruder TARGET=250
   TEMPERATURE_WAIT SENSOR=extruder MINIMUM=250
 {% endif %}

 M83
 G1 E55 F600
 G1 Y66 F8000
 G1 E55 F600
 G4 P500
 M106 S255
 G4 P4000
 G4 P200
 G1 E-3 F1000
 G1 Y86 F15000
 G1 Y66 F15000
 G1 Y91 F15000
 G1 Y66 F15000
 G1 Y96 F15000
 G1 Y68 F15000
 G1 E3 F1000
 M106 S{current_speed}
 SET_VELOCITY_LIMIT ACCEL={current_accel}
 M400

Attention! I have not tested the fully printed version of the bucket! If you are going to print it, I recommend gluing it with aluminum tape to reduce adhesion.