Gorpo or DJI mount for Rev Robotics extrusion
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
small gopro/DJI mount for the rev robotics metal extrusions to capture alternative angles of your robot!
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 53
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
This model was made as our team, 22948, needed to capture some footage before our national competition for our instagram. This model is a simple but useful one.
printed in PETG (can be done in PLA, but will not be as strong)
0.2 layer height
Support: yes, but only touching buildplate (if you want to use tree supps you must manually block out the screw hole from recieving supports)
No brim
Note: you will need an additional M5 to hold the screw, and 2 rev robotics screws and nuts to hold inside the extrusion
If encountering the problem of it being too big when importing it into your slicer, the correct dimensions are the following (with the bottom laying flat on the build plate):
Height: 16.5mm
Width: 54.6mm
Depth:17mm
Hope this design is useful, and enjoy :)