Active heater mount for Original Prusa Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Active heater mount to maintain heat in the enclosure for printing higher temp materials.
- Rating
- 4 / 5
- Likes
- 5
- Downloads
- 13
- Makes
- 1
- Views
- 255
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I have an old MK3S+ that I have in an Original Prusa Enclosure for printing higher temp materials, but it would never get much above 30°C, which isn't really hot enough for printing ASA/ABS. To help push the temperature higher, I found a heater that is small enough to fit inside the enclosure and also heats it up to a consistent 50°C and maintains the temperature.
To fit this into the enclosure, I designed a mount which uses the existing holes in the frame to hold it in place and it is bolted in using the spare M3 screws and nuts which came with the printer. It is mounted centrally at the rear and at the top of the enclosure, so the airflow doesn't affect the print or concentrate heat on any of the printer components (or the filament if you use the inside spool holder). There are 3 versions of the mount, 1 which is solid, 1 with the hex pattern and 1 which uses less material and prints quicker. I printed some TPU spacers to help with vibrations on the enclosure plastic screen, but you could use stick on foam if you have any issues.
Fitting can be a bit fiddly as it's difficult to get the nut onto the screw if you are fitting this to an assembled enclosure on your own, but it only requires 2 screws and nuts to hold it in place. Make sure to route the power cable and plug for the heater through the opening before fitting, as it won't fit through the gap after fitting. The printer power supply will also have to be removed to feed the plug through the gap in the rear of the enclosure.
I designed another part for this (Einsy door for fan by Scotsguard | Download free STL model | Printables.com) as I wanted to make sure that the electronics didn't get too hot when the fan was on.
In operation, the enclosure will heat up to a maximum indicated temperature of 60°C at the top of the chamber (on the enclosure thermometer), before settling down to around 50°C when printing ASA at 260 hotend/110°C bed. I have some other parts that I've added to the enclosure to help retain the heat (door seals, hole plugs etc), so your setup might not achieve exactly the same temps, but it should be pretty close, as the heater will keep pumping out heat until it reaches 50°C.
The heater for the mount is this one from Amazon (GAIATOP Space Heater, 500W Energy Efficient Space Heaters for Indoor Use, PTC Ceramic Fast Heating Electric Desk Heater, Overheating & 45°Tip-Over Protection Portable Mini Heater for Office Home Black : Amazon.co.uk: Home & Kitchen).
As with all electronics, please check your wiring before turning it on and any modifications are at your own risk!
I printed this in ASA to cope with the heat. 0.4 nozzle with 3 walls and 20% infill.