Eero 2nd gen (cupcake) Ikea Hauga bookshelf wall mount bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A slip-on wall mount bracket for the Eero Gen 2 cupcake pod. It slides around the side of the case and over a shelf.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 72
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print with supports for the shelf slot, and in something that can take a bit of flex. The wall-side clamp is preloaded a bit to clamp well. The shelf slot is a close fit, but shouldn't stretch, as it would separate the layer lines.
Due to the addition of the C clamp arm, the print orientation is not the same as the original, which results in a worse quality surface. v2 changes out the smooth large radius for a chamfer with a smaller radius on the lower edge, as well as fills in the corner to help with bed adhesion on the skinny leg.
