Enclosure for BusPirate 3.6
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Just another enclosure for the Bus Pirate 3.6 PCB.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 47
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Since I did not like any of the models I found (because they did not fit or because they had a cutout for the ICSP), I made another model. The pcb is pressed (sort of) between the pegs of the lower and upper shell and fixed with the 4 screws (since I do not like snap-together enclosures). For the 4 leds, I put a short piece of clear filament in each of the holes. It fits snugly, if you are afraid, you may use a drop of superglue.
You need 4 screws M3x8 or similar.
Layer height: 0.3mm
Printed with PETG (any other filament should do as well, but I don't know how good the screws will grab in PLA).