Sovol SV08 Hotbed Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Yet another modified mount for the Sovol SV08 Hotbed. Modified version of the original mount.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 53
- Makes
- 0
- Views
- 528
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is yet another hotbed mount for the Sovol SV08. It is a remix of the original design. This was inspired by several other options to fix the taco beds already out there.
This mount is designed to work with silicone spacers; you will need longer screws for this. I designed this to use M4 heat set inserts. I pushed these in through the bottom. However, I have included the step file in case someone wants to modify this to work with nuts instead.
For the silicone spacers I used some 18mm ones off of amazon, but I cut them down to 10mm since I didn't want them too tall. I used the attached spacer jig to cut these with a razor blade.
https://www.amazon.com/dp/B09NNFQQ8T
For the screws I used some M4x16 flat head screws. You may need longer ones if you use taller spacers.
I used the screw_tilt_calculate function described by Wrath669 in his write-up to get it close and then I used the bed mesh to fine tune it. SV08BedTension/README.md at main · Wrath669/SV08BedTension · GitHub
One thing to note when using the inserts. If you're going to print high temp filaments. I would suggest making the base out of something that can stand up to the temps and don't over tighten screws. My first version I printed out of ABS and I had some of the inserts pull out. My second version I printed out of PET-CF17 and it's held up pretty well so far. It also helps if you insert them from the bottom.